This is 125KHz RFID Card used for Contactless transmission of data and supplies energy with no battery needed. Its Operating distance is Up to 100mm depending on antenna geometry. Operating frequency is 125KHz and Data transfer speed is 106 kbit/s.It is featured with Data integrity of 16 Bit C..
125KHz RFID Tag is used for sensing and identifying tagged people and objects for access control, automation, and a whole range of different applications. This basic RFID tag works in the 125kHz RF range and comes with a unique 32-bit ID. It is not re-programmable. This blank, smooth, and mildly fle..
RFID 13.56MHz Card use for Contactless transmission of data and supply energy with no battery needed. Its Operating distance is Up to 100mm depending on antenna geometry. Operating frequency is 13.56MHz and Data transfer speed is 106 kbit/s.It is featured with Data integrity of 16 Bit CRC, parity, b..
13.56MHz RFID Key Tag is used for sensing and identifying tagged people and objects for access control, automation, and a whole range of different applications.Operating on a frequency of 13.56MHz, these tokens are all pre-programmed with unique ID numbers to communicate wirelessly with RFID R..
1575 Mhz GPS Antenna for GPS and GSM module with 3 Meter Cable is designed to work in perfect harmony with MTK GPS module. Featuring water proof design for use in tough terrain and environment, it maximizes the potential of GPS module by bringing exceptional GPS signal reception performances. This m..
The 2.4GHz NRF24L01 Module with PA+LNA SMA Wireless Transceiver Antenna use the 2.4 GHz transceiver from Nordic Semiconductor, the nRF24L01 PA LNA. This transceiver IC operates in the 2.4 GHz band and has many new features. Take all the coolness of the nRF2401A and add some extra pipelines, buffers,..
This is FS1000A 315MHz RF Transmitter Receiver Module Wireless Link Kit For Arduino. This RF module comprises an RF Transmitter and an RF Receiver. The transmitter/receiver (Tx/Rx) pair operates at a frequency of 315MHz. An RF transmitter receives serial data and transmits it wirelessly through RF t..
ADS1115 16-Bit ADC-4 Channel with Programmable Gain Amplifier is used for micro-controllers without an analog-to-digital converter or when you want a higher-precision ADC, the ADS1115 provides 16-bit precision at 860 samples/second over I2C. The chip can be configured as 4 single-end input channels ..
CD74HC4067 High Speed CMOS 16-Channel Analog/Digital Multiplexer Breakout Module is a breakout board that mounts a 74HC4067 which is a 16-channel Analog multiplexer/demultiplexer that can route both analog and digital signals in both directions.1 of 16 input channels can be routed to 1 output or 1..
This is CH375B USB Disk Read-write Module USB Flash Disk For Arduino. USB interface in the current electronic products accounted for a very large share of the microcontroller. With USB interface communication using the CH375, CH375 is a USB bus interface chip to support USB-the Host and USB-Device/S..
CP2102 USB 2.0 to TTL UART Serial converter Module 5 Pin is a single chip USB to UART bridge IC. It requires minimal external components. CP2102 can be used to migrate legacy serial port based devices to USB.Features:Stable and reliable chipset CP2102.USB specification 2.0 compliant with full-speed ..
This is D1 Mini V2 NodeMcu 4M Bytes Lua WIFI Internet Of Things Development Board Based ESP8266, it is a mini WIFI board based on ESP-8266EX. 11 digital input/output pins, all pins have interrupt/PWM/I2C/one-wire supported(except D0) 1 analog input(3.3V max input) and a Micro USB connection.The deve..