Speed Measuring Sensor Counter Motor Test Groove Coupler Module For Arduino

  • Rs. 100.00 INR

TECH1200

Specifications:

  • The DO output interface can be directly connected to a micro-controller IO port, if there is a block detection sensor, such as the speed of the motor encoder can detect.
  • DO modules can be connected to the relay, limit switch, and other functions, it can also with the active buzzer module, compose alarm

 

Wiring Specification:

  • VCC Connect the positive 3.3 5 v power supply
  • GND Connect power negative
  • DO TTL switch signal output
  • AO This module does not work

 

Descriptions:

  • Using imported groove optical coupling sensor, width 5mm.
  • It have the output state light, if output high level, the lights are off. if output low level ,it on.
  • If it covered, it will output high level; otherwise it output low level.
  • Good signal and waveform, with strong driving ability for more than 15mA.
  • The working voltage of 3.3V to 5V.
  • Output: digital switch output (0 and 1).
  • Equipped with a fixed bolt hole, easily install.
  • Small board PCB size: 3.2 cm x 1.4 cm.
  • Use the LM393 wide voltage comparer.

 

Application:

  • Widely used in motor speed detection, pulse count, the position limit, etc

We Also Recommend