ADXL345 3-Axis Digital Acceleration of Gravity Tilt Module for Arduino

  • Rs. 180.00 INR



  • Supply Voltage: 2.0 - 3.6 VDC
  • Ultra Low Power: As low as 23 uA in measurement mode, 0.1uA in standby mode at 2.5V
  • SPI or I2C Communication
  • Single Tap / Double Tap Detection
  • Activity / Inactivity Sensing
  • Free-Fall Detection



  • The ADXL345 is a small, thin, low power, 3-axis MEMS accelerometer with high resolution (13-bit) measurement at up to +/-16 g. Digital output data is formatted as 16-bit two’s complement and is accessible through either an SPI (3- or 4-wire) or I2C digital interface.
  • The ADXL345 has special sensing abilities. The single and double tap sensing detects when a single, or two simultaneous, acceleration events occur. Activity and inactivity sensing detect the presence or lack of motion. Free-fall sensing compares the acceleration on all axes with the threshold value to know if the device is falling. All thresholds levels that trigger the activity, free-fall, and single tap/double tap events are user-set levels. These functions can also be mapped to one of two interrupt output pins. An integrated, patent pending 32-level first in, first out (FIFO) buffer can be used to store data to minimize host processor intervention.
  • The ADXL345 is well suited to measure the static acceleration of gravity in tilt-sensing applications, as well as dynamic acceleration resulting from motion or shock. Its high resolution (4 mg/LSB) enables measurement of inclination changes less than 1.0°. Furthermore, low power modes enable intelligent motion-based power management with threshold sensing and active acceleration measurement at extremely low power dissipation.



  • Handsets
  • Medical Instrumentation
  • Gaming and Pointing Devices
  • Industrial Instrumentation
  • Personal Navigation Devices
  • Hard Disk Drive (HDD) protection
  • GND   This pin must be connected to ground
  • VCC   Supply Voltage
  • CS   Chip Select
  • INT1   Interrupt 1 Output
  • INT2   Interrupt 2 Output
  • SDO   Serial Data Output (SPI 4-Wire) / I2C Address Select
  • SDA / SDI / SDIO Serial Data I2C / Serial Data Input (SPI 4-WIRE) / Serial Data Input and Output (SPI 3-Wire)
  • SCL/SCLK Serial Communications Clock

We Also Recommend