The APM Power Module is a simple way of providing your APM 2.5/6 with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 6S LiPo battery. The Pow..
Ardupilot APM 2.8 Flight Controller with Built-in Compass is an amazing flight controller allows the user to turn any fixed wing, rotary wing, or multi-rotor vehicle (even boats and cars) into a fully autonomous vehicle, capable of performing a wide range of tasks, even programmed GPS missions with ..
For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M. The innovative All-in-one design simplifies installation and saves space and weight...
By introducing the product DJI NAZA-M Lite V1.1 with GPS Kit, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M. The innovative All-in-one design simplifies install..
DJI Naza-M V2 Multi-Rotor Flight Controller With GPS Module Supports nine multi-rotor configurations, the DJI NAZA-M V2 Controller With GPS acts as the brains of the aircraft, managing pilot input and interpreting data from the various sensors, helping maintain a stable flying condition. There..
The next evolution of the rotor revolution is here!! The KK2.1.5 Multi-rotor LCD Flight Control Board With 6050MPU And Atmel 644PA is packing new found power with updated sensors, memory and header pins.
The KK2.1.5 is next big evolution of the first generation KK flight control boards. The LCD s..
Multicopter Flight Controller Power Distribution Board PCB for Battery and ESC Connection boards are great for smaller multirotor builds. They’re compact and lightweight and offer large solder pads – making them easy to work with. These boards can handle some serious current – up to 20A per output f..
Designed for serious quad racers and freestyle maniacs, the Naze32 flight controller is undeniably the most used, recognised and supported flight controller in the scene today. With a 32bit ST micro processor and a host of equally impressive sensors, this Rev6 Acro version comes with 16mbit memory a..
OpenPilot CC3D Flight Controller Straight Pin STM32 32-bit Flexiport is an all-in-one stabilization hardware which runs the OpenPilot firmware. It can fly any airframe from fixed wing to an octocopter and is configured and monitored using the OpenPilot Ground Control Station (GCS) software. The CC3D..
Pixhawk 2.4.8 PX4 32 Bit Flight Controller with Switch and Buzzer is based on the rapidly evolving and refined Ardupilot mega or “APM”, an open-source project from 3DR robotics. This amazing flight controller allows the user to turn any fixed-wing, rotary-wing, or multirotor vehicle (even boats and ..
OSD OLED Display for Pixhawk 2.4.8 PIX PX4 Flight Control is suitable for flight control of Pixhawk, etc. and is used to display the status information of aircraft. This module is connected to Pixhawk’s I2C interface.This information includes on Display:Arming failure messages Flight modeBatter..
Matek PDB-XT60 with BEC 5V and 12V has been engineered to provide the highest possible performance and reliability in a 36*50mm & 4 layers PCB. It distributes power from a LiPo pack to 6 ESCs, as well as providing synchronized & regulated DC 5V outputs & linear regulated DC 12V for power..