KK2.1.5 Multi-rotor LCD Flight Control Board With 6050MPU And Atmel 644PA

The next evolution of the rotor revolution is here!! The KK2.1.5 Multi-rotor LCD Flight Control Board With 6050MPU And Atmel 644PA is packing new found power with updated sensors, memory and header pins.

The KK2.1.5 is next big evolution of the first generation KK flight control boards. The LCD screen and built in software makes install and setup easier than ever. A host of multi-rotor craft types are pre-installed, simply select your craft type, check motor layout/propeller direction, calibrate your ESCs and radio and you’re ready to go! All of which is done with easy to follow on screen prompts!

The original KK gyro system has been updated to an incredibly sensitive 6050 MPU system making this the most stable KK board ever and allowing for the addition of an auto-level function. At the heart of the KK2.1 is an Atmel Mega644PA 8-bit AVR RISC-based micro-controller with 64k of memory. An additional polarity protected header has been added for voltage detection, so no need for on-board soldering. A handy piezo buzzer is also included for audio warning when activating and deactivating the board.

The KK2.1 added polarity protection to the voltage sense header and a fuse protected buzzer outputs, in case something is accidentally plugged in incorrectly. The voltage sense line has been updated for better accuracy. The board is clearly labeled and the voltage sense line color has been changed to red for easy identification, making installation and connections a snap.

The KK2.1 Multi-Rotor controller manages the flight of (mostly) multi-rotor Aircraft (Tricopters, Quadcopters, Hexcopters etc). Its purpose is to stabilize the aircraft during flight and to do this, it takes signals from on-board gyroscopes (roll, pitch and yaw) and passes these signals to the Atmega324PA processor, which in-turn processes signals according the users selected firmware (e.g. Quadcopter) and passes the control signals to the installed Electronic Speed Controllers (ESCs) and the combination of these signals instructs the ESCs to make fine adjustments to the motors rotational speeds which in-turn stabilizes the craft.

The KK2.1 Multi-Rotor control board also uses signals from your radio system via a receiver (Rx) and passes these signals together with stabilization signals to the Atmega324PA IC via the aileron; elevator; throttle and rudder user demand inputs. Once processed, this information is sent to the ESCs which in turn adjust the rotational speed of each motor to control flight orientation (up, down, backwards, forwards, left, right, yaw).

If you’re new to multi-rotor flight or have been unsure about how to setup a KK board then the KK2.1 was built for you. The 6 Pin USBasp AVR programming interface ensures future software updates will be quick and easy.

Note : Jumper Cables are provided if available from Manufacturer.

Features:

• Most stable KK Board ever.
• 6050 MPU system based.
• Easy graphical interfacing with receiver.
• In Built firmware.
• Easy to use for beginners.

Specifications:

Model	KK2.1.5
Input Voltage (V)	4.8V-6.0V
Firmware	Pre-installed firmware
Sensors	6050 MPU
Auto-level	Yes
Processor	Atmel 644PA
AVR interface	Standard 6 pin
Micro-SD Card Slot	No
Signal from Receiver	1520us (5 channels)
Signal to ESC	1520us
Length (mm)	50.5
Width (mm)	50.5
Height (mm)	12
Weight (gm)	21

Package Includes:

• 1 x KK 2.1.5 Multi-rotor LCD Flight Controller Board
• 1 x Piezo buzzer.