Menu
Your Cart

Auto-Calibrating Line Sensor LSS05

Auto-Calibrating Line Sensor LSS05
Auto-Calibrating Line Sensor LSS05
Auto-Calibrating Line Sensor LSS05
Auto-Calibrating Line Sensor LSS05
Auto-Calibrating Line Sensor LSS05
Auto-Calibrating Line Sensor LSS05
Auto-Calibrating Line Sensor LSS05
₹1,035
Ex Tax: ₹877.12
  • Stock: In Stock
  • SKU: TECH1936
  • Brand: Cytron
Auto-Calibrating Line Sensor LSS05 is super easy to use. Comes with 5 pairs of IR transmitter and receiver. It can easily covers and detects line width of 1cm to 3cm, dark color or bright color. After power up, 1 press to the push button (at the side), it starts "scanning" the surface under it, calibrating the threshold between dark and bright. It takes just 4 to 5 seconds only. Once calibration is done, these settings are stored in internal non-volatile memory, it will still "recognize" the line even after power recylce (Off and On) again. The outputs are digital (0V or 5V) to indicate line detected or no line, so reading the line position is as simple as reading digital signal.

Line following is an important application in robotics. It is being used in AGV (Automated Guided Vehicle) and allow robots to navigate and perform tasks. There are many type of line sensing method, if you use normal Infrared transmitter and receiver, it will be very troublesome to calibrate, right? Well, this very simple to calibrate line sensor might help you.

Features:
  • 5V power, reserve polarity protected
  • 5 digital outputs representing logic of 5 IR sensor, represented with indicator each.
  • Sensor refresh rate at ~100Hz, each sensor.
  • Calibration button for easy of calibratiing sensor:
  • 1 press to start calibration
  • 2 press to toggle logic into Dark On mode, to sense dark line
  • 3 press to toggle logic into Bright On mode, to sense bright line

Specifications:

Brand

Cytron

Supply Voltage (V)

5

Length (mm)

64

Width (mm)

28

Height (mm)

10

Weight (gm)

8


Documents:

Tutorials:
Package Includes:
  • 1 x LSS05 board
  • 1 x LSS05 Cable
  • 2 x 8mm PCB spacer (screw/screw)

Write a review

Note: HTML is not translated!
Bad Good
Captcha
We use cookies and other similar technologies to improve your browsing experience and the functionality of our site as per our Privacy Policy.