This is a simple 4 cell AA battery holder. The 5-inch cable is terminated with a standard 5.5×2.1mm, center positive barrel jack connector. The connector mates with the barrel jack on the?Arduino?(among a number of other products) allowing you to easily make your project battery powered.
Note: the average voltage regulator has about 1V of dropout (but can vary greatly). This pack, with normal alkaline batteries, will output ~5.5V causing a normal 5V board to run at around 4 to 4.5V. This depends on a lot of what board and processor you are using with the battery pack.
- Dimensions : 62 x 57 x 16 mm.
- Weight: 15 gm.
- Wire Length: 14 cm.
- Voltage: 6V.
- Material: ABS.
- Easy install, convenient to use
- Color: Black.
Package Includes :
1 x 4xAA Battery Holder Case without cover.(Battery Not Included).