Menu
Your Cart

18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board

18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board
₹200.00
Ex Tax: ₹169.49
  • Stock: In Stock
  • SKU: TECH1497

The 18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board is compatible for Arduino, Raspberry Pi,esp8266 or Sensors with protection. The output current can reach upto 2A.

This 18650 Battery Holder/Development Board is compatible With Raspberry Pi3B/3B+ that comes with a built-in battery charging module as well as an I2C battery monitoring system for the raspberry pi. If you want to convert your project into a portable solution then this is a solution for you this board comes with a 18650 Li-ion Battery holder and a charging module for the battery this board can supply a maximum of up to 6A current to the raspberry pi via its output terminals which is more than enough for the normal operation of the raspberry pi.

This module has a built-in battery monitoring system, which can monitor the battery voltage and send the information via the I2C protocol to the raspberry pi. This can come in handy while building a self-powered raspberry pi project which can also monitor the battery voltage and alert when the battery voltage falls below a certain limit.

Features:

  • This module is suitable for 18650 battery only
  • over-charging protection and over-discharge protection
  • Micro USB port Charging Input
  • A type USB Output
  • Charge current: 0.5A
  • 1 switches to control the USB output
  • Input voltage: 5 ~ 8V
  • Three 3V 1A output interface
  • Three 5V 2A output interface
  • LED light, green for full of charge, red for under charging
  • Follow the direction "+" "-" on the PCB

Specifications:

Operating Voltage (VDC)

5

Max. Output Current (A)

6

Length (mm)

100

Width (mm)

30

Height (mm)

30

Weight (gm)

10


Note:

  • This module is suitable for 18650 battery only
  • This module can be powered or for raspberry pi and sensor at the same time
  • This module output current up to 2A
  • (This product does not contain 18650 battery installation, be careful of the battery positive and negative when install, do not reverse. Please follow the + - direction on the PCB and do not follow the positive and negative directions on the battery holder)

Package Includes:

  • 1 x 18650 Battery Charge Holder 0.5A USB Charging Protection Board 

Write a review

Note: HTML is not translated!
Bad Good
Captcha
We use cookies and other similar technologies to improve your browsing experience and the functionality of our site as per our Privacy Policy.